Hi I have a little problem in bootloading the 5402 in the parallel mode. I'm using a 8-bit wide flash memory for bootloading the DSP (5402), but I cannot get any result; could anyone help me with an example of a properly programmed flash memory cintents for bootloading in parallel mode. Many thanks, Yaser. |
|
Parallel Bootloading the 5402
Started by ●September 25, 2003
Reply by ●September 25, 20032003-09-25
dear friend hi as you know @ start up MP/MC flag is samled with it's hardware pin ,& it is so important to define your boot loader algorithm plz check it first.then check sequence of your booting,for this point that parallel bootloading is not the first method in the sequential check.(for example HPI method is the first). regards mohammad alivandi --- Yaser Namazi <> wrote: > Hi > > I have a little problem in bootloading the 5402 in > the parallel > mode. I'm using a 8-bit wide flash memory for > bootloading the DSP > (5402), but I cannot get any result; could anyone > help me with an > example of a properly programmed flash memory > cintents for > bootloading in parallel mode. > > Many thanks, > Yaser. > > _____________________________________ > Note: If you do a simple "reply" with your email > client, only the author of this message will receive > your answer. You need to do a "reply all" if you > want your answer to be distributed to the entire > group. > > _____________________________________ > About this discussion group: > > To Join: Send an email to > To Post: Send an email to > > To Leave: Send an email to > Archives: http://www.yahoogroups.com/group/c54x > > Other Groups: http://www.dsprelated.com > ">http://docs.yahoo.com/info/terms/ __________________________________ |