=?x-unknown?B?Q2FuwrR0?= configure the DSP TMS320C6745

Hi

Has anyone ever used the TMS320C6745?
I can´t configure it? I open the Code Composer Studio Setup and create a board, i choose the SD510USB Emulator (I´m working with the XDS510 USB PLUS Emulator)and i also choose the processor type c6745 which includes an ICEPICK_C and the TMS320C674XP.
When the setup is finished i save and quit and the Code Composer Studio starts.

The problem comes when i try to connect the target, i have the following error:

Error connecting to the target:
Error 0x80000240/-1146
Fatal Error during: Initialization, OCS,
Invalid data was scanned by the emulation controller.
Verify the board setup to make sure the scan chain is properly
defined.
If the setup is correct, then RESET EMULATOR. This will disconnect each
target from the emulator. The targets should then be power cycled
or hard reset followed by an emureset and reconnect to each target.
I/O Port = 510

Board Name: Target_c6745
Cpu Name: TMS320C674XP_0

Abort: Close Code Composer Studio.
Retry: Try to connect to the target again.
Cancel: Remain disconnected from the target
Diagnostic: Run diagnostic utility.

I don´t know if the problem is the configuration or the Hardware with the JTAG, has anybody a diagramm of how to connect the TMS320C6745 with the JTAG?

Thanks in advance.

_____________________________________ Start a New Thread

HI

What brand of emulator do u use??

Best regards
Peter

On 30/04/2009, l...@cidesi.mx wrote:
> Hi
>
> Has anyone ever used the TMS320C6745?
> I cant configure it? I open the Code Composer Studio Setup and create a
> board, i choose the SD510USB Emulator (Im working with the XDS510 USB PLUS
> Emulator)and i also choose the processor type c6745 which includes an
> ICEPICK_C and the TMS320C674XP.
> When the setup is finished i save and quit and the Code Composer Studio
> starts.
>
> The problem comes when i try to connect the target, i have the following
> error:
>
> Error connecting to the target:
> Error 0x80000240/-1146
> Fatal Error during: Initialization, OCS,
> Invalid data was scanned by the emulation controller.
> Verify the board setup to make sure the scan chain is properly
> defined.
> If the setup is correct, then RESET EMULATOR. This will disconnect each
> target from the emulator. The targets should then be power cycled
> or hard reset followed by an emureset and reconnect to each target.
> I/O Port = 510
>
> Board Name: Target_c6745
> Cpu Name: TMS320C674XP_0
>
> Abort: Close Code Composer Studio.
> Retry: Try to connect to the target again.
> Cancel: Remain disconnected from the target
> Diagnostic: Run diagnostic utility.
>
> I dont know if the problem is the configuration or the Hardware with the
> JTAG, has anybody a diagramm of how to connect the TMS320C6745 with the
> JTAG?
>
> Thanks in advance.
>
>
> _____________________________________
>

_____________________________________ Start a New Thread