hello!
I have some trouble with dsk6711 emif.
the value in the EMIF registers is:
(this is according to my board condition)
*(unsigned int *)EMIF_GCR =0x30f8;
*(unsigned int *)EMIF_CE0 =0x30;
*(unsigned int *)EMIF_CE1 =0xffffff03;
*(unsigned int *)EMIF_CE2 =0xffffff23;
*(unsigned int *)EMIF_SDCTRL=0x07117000;
*(unsigned int *)EMIF_SDRP =0x61a;
*(unsigned int *)EMIF_SDEXT =0x54519;
the AREADY pin is pulled high on my board
When I access the CE2,I check CE2,AWE,ARE and AOE,and there is no
change on my oscilloscope(100MHz).I am confused,what is the matter
with my board.
thinks
shred_gao
Reply by Mike Dunn●January 1, 20042004-01-01
hello shred_gao,
Sometimes it is very difficult to trigger a scope on a single event.
Try writing a simple endless loop that reads from [or writes to] the
first address of CE2, increments for 1M times and starts over.
Your scope should be able to pick up the signals.
mikedunn
shred_gao <c...@sina.com>
wrote:
hello! I have some trouble with dsk6711 emif. the value in the EMIF registers is: (this is according to my board
condition) *(unsigned int *)EMIF_GCR =0x30f8; *(unsigned int
*)EMIF_CE0 =0x30; *(unsigned int *)EMIF_CE1 =0xffffff03; *(unsigned
int *)EMIF_CE2 =0xffffff23; *(unsigned int *)EMIF_SDCTRL=0x07117000; *(unsigned int *)EMIF_SDRP =0x61a; *(unsigned int *)EMIF_SDEXT
=0x54519; the AREADY pin is pulled high on my board When I access the
CE2,I check CE2,AWE,ARE and AOE,and there is no change on my
oscilloscope(100MHz).I am confused,what is the matter with my board. thinks shred_gao _____________________________________ Note: If
you do a simple "reply" with your email client, only the author of this message
will receive your answer. You need to do a "reply all" if you want your answer
to be distributed to the entire
group.
_____________________________________ About this
discussion group: