DSPRelated.com
Forums
   Forums    More Forums    c6x  

C6416 board emulation problems

Started by spade7cn ●February 25, 2004
recently I happened to made a C 6416 PCB board myself.and I
bought seed-XDSUSB2.0 emulator to connect to my PCB board to start
emulations.but unfortunatelty ,when I start CCS,the emulator cannot
connect to the CPU on the board after I had installed all the
software and drivers necessarily needed.It shows the error NO.<-
1153>,tell me that the address 0x00000000 kept indicating "Not
Ready",and advice me to reset the CPU.and I reset the CPU several
times before starting CCS,it doesn't work either.
Now I am disconsolate about it so much.I wanted to know is there
anyone who ever emulated C6416? and is there anyone who can tell me
under what exactly conditions that can make the emulator connecting
to the board succesfully.(like how the JTAG interface be connected
and are there any pin of the 6416 should be configed before start
CCS?)
thanks alot!!



Reply by Mike Dunn ●February 29, 20042004-02-29
 
I believe the seed-XDSUSB2.0 emulator works with TI CCS2.x supported devices.
1. Have you used the emulator with any other boards??
2. I believe that this emulator uses standard TI emulation drivers.  Make sure that you select the c64x driver that matches your silicon [the two drivers support c64x v1.0x and 'v1.1 and newer'.
3. Run the TI xdsprobe utility to verify scan chain connections.  In /ti/cc/bin dir from a DOS prompt [replace "<xx>" with actual values:
xdsprobe -i -p <seed-emulator-address> -f <path_and_name_of_seed_cfg_file>
 
mikedunn

spade7cn <s...@yahoo.com.cn> wrote:
recently I happened to made a C 6416 PCB board myself.and I
bought seed-XDSUSB2.0 emulator to connect to my PCB board to start
emulations.but unfortunatelty ,when I start CCS,the emulator cannot
connect to the CPU on the board after I had installed all the
software and drivers necessarily needed.It shows the error NO.<-
1153>,tell me that the address 0x00000000 kept indicating "Not
Ready",and advice me to reset the CPU.and I reset the CPU several
times before starting CCS,it doesn't work either.
Now I am disconsolate about it so much.I wanted to know is there
anyone who ever emulated C6416? and is there anyone who can tell me
under what exactly conditions that can make the emulator connecting
to the board succesfully.(like how the JTAG interface be connected
and are there any pin of the 6416 should be configed before start
CCS?)
thanks alot!!

_____________________________________
Note: If you do a simple "reply" with your email client, only the author of this message will receive your answer. You need to do a "reply all" if you want your answer to be distributed to the entire group.

_____________________________________
About this discussion group:

To Join: Send an email to c...@yahoogroups.com

To Post: Send an email to c...@yahoogroups.com

To Leave: Send an email to c...@yahoogroups.com

Archives: http://www.yahoogroups.com/group/c6x

Other Groups: http://www.dsprelated.com

Yahoo! Groups Links

<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/c6x/

<*> To unsubscribe from this group, send an email to:
c...@yahoogroups.com

<*>