|
Dear All, i am trying to configure EDMA to transfer data from one memory location to another. I am having doubts 1.How to determine which channel is most suitable for configuring,does it depend on synchronization event,i want to trigger EDMA transfer on change of some variable value then if i can trigger interrupt using IRQ_enable on external pin4 and then use channel4,is this procedure right or there is some other procedure. 2.Which channel is most suitable for chaining transfer from one channel to another. 3.Is it better to configure EDMA transfer in DSP-BIOS or by writing register values manually If anone can tell me any example or manual where the above issues have been addressed. Many Thanks in advance, Regards, Mayank Agarwal __________________________________ |
EDMA Configure-Revisited
Started by ●December 15, 2004
