Help Over Flash programming using XDS510

Hi,
     I am using XDS510 USB PLUS JTAG Emulator for programming flash inside
TMS320F2810. Currently I am achieving this by selecting "Tools->F28XX
On-chip Flash programmer" option from code composer studio. I am planning
to automate programming. I think I can use command line arguements for
programming through DOS prompt. I didn't find any help over programming
through command line for XDS510 USB PLUS JTAG Emulator.
Any help to resolve the issue is highly appreciated.
Thanks,
Vijay

On Thu, 17 Jul 2008 13:54:49 -0500, "vijaykumar1981"
<vijay1981@email.com> wrote in comp.dsp:

> Hi,
>      I am using XDS510 USB PLUS JTAG Emulator for programming flash inside
> TMS320F2810. Currently I am achieving this by selecting "Tools->F28XX
> On-chip Flash programmer" option from code composer studio. I am planning
> to automate programming. I think I can use command line arguements for
> programming through DOS prompt. I didn't find any help over programming
> through command line for XDS510 USB PLUS JTAG Emulator.
> Any help to resolve the issue is highly appreciated.
> Thanks,
> Vijay
> 
http://focus.ti.com/dsp/docs/dspplatformscontento.tsp?sectionId=2&familyId=1406&tabId=2026#guisdf

http://emulators.spectrumdigital.com/utilities/sdflash/

It is GUI, not command line, but does not require use of Code Composer
Studio.

-- 
Jack Klein
Home: http://JK-Technology.Com
FAQs for
comp.lang.c http://c-faq.com/
comp.lang.c++ http://www.parashift.com/c++-faq-lite/
alt.comp.lang.learn.c-c++
http://www.club.cc.cmu.edu/~ajo/docs/FAQ-acllc.html

vijaykumar1981 wrote:

> Hi,
>      I am using XDS510 USB PLUS JTAG Emulator for programming flash inside
> TMS320F2810. Currently I am achieving this by selecting "Tools->F28XX
> On-chip Flash programmer" option from code composer studio. I am planning
> to automate programming. I think I can use command line arguements for
> programming through DOS prompt. I didn't find any help over programming
> through command line for XDS510 USB PLUS JTAG Emulator.
> Any help to resolve the issue is highly appreciated.

Don't need any of that stuff.

Load the flashloader by the bootloader procedure, then program the flash 
via RS-232. That's all it takes.


Vladimir Vassilevsky
DSP and Mixed Signal Design Consultant
http://www.abvolt.com