YUHUA XDS510 USB 2.0 Emulator

Hi everybody,
I'm a newbye in DSP development.
I just buyed a XDS510 USB 2.0 "manufactured" by YUHUA Electronics from an ebay Honk Kong reseller.
Furnished windows drivers are from "SEED International" and seems to be installed correctly. But the Emulator Reset Utility can't reset the device, signaling me "SEED USB2.0 XDS510 CARD RESET FAILED, ffff".
Repeating the reset command while the emulator is disconnected the message is the following: CANNOT DETECT TARGET POWER OR USB DRIVER IS NOT INSTALLED.
So the device seem to be detected by the system.

Besides I can't install it under CCS 3.3 (EVM Edition).
Does anybody can help me in any way?

Thanks a lot!!!
- sciams - Start a New Thread

sciams,

On Wed, Aug 6, 2008 at 9:04 AM, wrote:
> Hi everybody,
> I'm a newbye in DSP development.
> I just buyed a XDS510 USB 2.0 "manufactured" by YUHUA Electronics from an
> ebay Honk Kong reseller.
> Furnished windows drivers are from "SEED International" and seems to be
> installed correctly. But the Emulator Reset Utility can't reset the device,
> signaling me "SEED USB2.0 XDS510 CARD RESET FAILED, ffff".

Interesting - this is not a standard error message.

Refer to
http://www.dsprelated.com/blogs-1/nf/Mike_Dunn.php
and the archives of this group to run the 'xdsprobe' utility and post
the results.

mikedunn
> Repeating the reset command while the emulator is disconnected the message
> is the following: CANNOT DETECT TARGET POWER OR USB DRIVER IS NOT INSTALLED.
> So the device seem to be detected by the system.
>
> Besides I can't install it under CCS 3.3 (EVM Edition).
> Does anybody can help me in any way?
>
> Thanks a lot!!!
> - sciams -

--
www.dsprelated.com/blogs-1/nf/Mike_Dunn.php Start a New Thread